You can connect two single zone (mono) pads to a stereo jack using Y-splitter cable and configure these two pads (inputs) as individual pads (which is set by default).petercarr90 wrote:I'd like to know if I can use it contemporary with mono and stereo jacks... for example a stereo snare and two mono toms...
dmitri wrote:It's 245x175x50mm.
jtiger102 wrote:dmitri wrote:It's 245x175x50mm.
Thanks.
As a follow up, would you be able to offer the 32 input version mounted in in the 1U chassis that is used for the 56 input model?
chain wrote:Hi,
Does this include positional sensoring?
Will this work with the new yamaha dtx silicone pads?
Do yamaha hi-hats work well with the module or are the rolands more suitable?
Does it produce different sounds when hi hat is closed and then stepped on like vh12 and 13?
Is the cymbal roll good or is it like alesis trigger io?
dmitri wrote:chain wrote:Hi,
Does this include positional sensoring?
It says in the description - "With an optional Positional Sensing addon board included it will cost 25GBP more"Will this work with the new yamaha dtx silicone pads?
I tested it with XP120SD and all 3 zones worked fine.Do yamaha hi-hats work well with the module or are the rolands more suitable?
If you mean a HiHat controller than either brand will work fine. As far as I know, with Yamaha HiHat controllers you have to use a crossover cable, i.e. a wire from a tip on one side of a cable goes to a ring on another side of the cable and vice verse.Does it produce different sounds when hi hat is closed and then stepped on like vh12 and 13?
It will depend on your chosen drum synth soft/vst.Is the cymbal roll good or is it like alesis trigger io?
What do you mean by "good cymbal roll" and "like alesis roll"?
chain wrote:When I do a cymbal roll/ wash with my alesis io + addctive drums instead of a continuos and fluid sound I hear all the hits. I am not sure if I am explaining well.
How much would it cost to ship to Portugal?
Users browsing this forum: Bing [Bot], Google [Bot] and 81 guests