Hall Sensor SS495A does not work.

Discussions related to MegaDrum Hardware

Hall Sensor SS495A does not work.

Postby BerlinKhan » Sat Aug 17, 2019 8:22 pm

Hello everyone,,
I'm a bit desprate.
First of all, I'm from Germany, so I have to deal with the hall sensor I can get here easily.
Somewhere used the SS495A and got good results.
internet cafe near me gaming

So i brought one, and tested it quick on a breadboard, before I even made the case for my megadrum kit.
The hall sensor and the neodym magnet worked. I was happy.
Ok, the range did't fit, but I have to adjust it, when it is in a case.

Now I put the megadrum kit, with the positional sensing board in a proper housing.
Before I wanted to solder in the hall sensor in its own housing, I tested its function again with a breadboard.
Nothing happend.

I double checked everything.
I looked up in the data sheet of the SS495, i got the pins right.
I traced the wires from pins on the hall sensor to the pins on the positional sensing board.:

V+ -> pin 40
V- -> GND
Output - > pin 38

It is all as it should be, but it does nothing at all.
Nothing.

I even unplugged the positional sensing board ( the jumper in mind) and tried it, again nothing.
Oh jeah, I even got another SS495, just in case I damaged the first one. The same: nothing.

Has anyone any clue?

Or can anyone recoment a good hihat controller?
Roland, Yamaha, Alesis, the cheap Millenium Stuff?

Thx.
BerlinKhan
 
Posts: 3
Joined: Wed Aug 07, 2019 7:26 pm

Re: Hall Sensor SS495A does not work.

Postby dsteinschneider » Wed Sep 04, 2019 1:47 am

Hi BerlinKhan,

I recently posted these steps I took to build my DIY hall sensor hi-hat controller:

https://www.megadrum.info/forums/viewtopic.php?f=4&t=4399
dsteinschneider
 
Posts: 71
Joined: Fri Jan 19, 2018 12:49 am


Return to MegaDrum Hardware

Who is online

Users browsing this forum: No registered users and 105 guests

cron