Page 2 of 2

Re: Enhancing false trigger detection on hard hits and rimsh

PostPosted: Fri Feb 08, 2019 6:48 pm
by airflamesred
Can you post some settings Daniele?

Re: Enhancing false trigger detection on hard hits and rimsh

PostPosted: Thu Feb 14, 2019 1:04 am
by daniele99
I'm uploading a video on yt: https://youtu.be/FoTquzFtt0o

Notice that i didn't have that issue before with an older firmware-
When it happens no activity from the led too
My snare has a voltage divider and no rectifier, it sends positive first half

My settings are:

Positional lvl: 2 Low: 7 Hi:11

Snare H: Snare R:
Th: 7 9
Hi lvl: 1020 520
retrigger: 6 11
dynlvl: 8 8
dyntime: 16/24 20
minscan: 30 24
curve: log2C log2C

Third zone:
dualmidpoint: 4
dualmidwidth: 9

All other gains, comps and lvlshift are: 0
Crosstalk disabled, all 0

Re: Enhancing false trigger detection on hard hits and rimsh

PostPosted: Fri Feb 15, 2019 11:33 am
by daniele99
There should be something strange in my snare circuit, cause when i touch and slightly move the resistor it seems the problem disappear...some more tweaking and i'll back. I don't know what type of relationship could it have with this issue but let's try. Thank you by now.

Re: Enhancing false trigger detection on hard hits and rimsh

PostPosted: Wed May 15, 2019 10:51 am
by maru_engineering
Hi Danielle99

Did you find out the fix? I'm experiencing exactly the same behavior: after a strong rim hit sometimes (especialy if the immdediate next shot is low strenght head) the head seems to be suppressed until it gets a good wack...

To put it in a completely un-enginner language, it feels like the strong rim hit is sometimes "clogging" the head channel - that is until it gets unclogged by a strong head hit.... :roll: