www.megadrum.info

hi all, with regards to the switch on the hi hat pedal, can anyone recommend one?

Any SPDT toggle switch are good for switching the pedal impedance

ok kl, so am i right in saying:

pin 2 is the pin in the middle of my switch, and goes to the tip of jack 1
pin 1 is one of the outer pins on the switch and is connected to pin 5 of the 40 way
pin 3 is the opposite of the outer pins n my switch and is cnnected to pin 3 of the 40 way.

the only reason why i ask this is because my switch has 6 pins.

regards

marc

I'm not sure I understand what switch you're asking about and why it has 6 pins.

its because i believe its a DPDT ? can i still use this as a SPDT?

If soldering a pedal impedance input selection switch using pinout on the diagram is too confusing, just don't use it and use two input jacks and plug your pedal to one of these jacks.

its not difficult in any way, i just picked up the wrong one, and believe i can use it in the same way, i was just trying to clarify if that was definately the case.

regards

Marc

It looks like pin 2 goes to the ring, see the schematics
http://www.megadrum.info/schematics.php

it looks like its to the tip to me. is it: left part of the jack working towards the right:

sleeve, ring, then tip?

regards

marc

From left to right I think it is Sleeve Tip and Ring.

I hope I am right otherwise mine is wrong